Char-Broil Gourmet 3-Burner TRU-Infrared Model# 463251713 - Discontinued

Char-Broil Gourmet 3-Burner TRU-Infrared Model# 463251713
Char-Broil Gourmet 3-Burner TRU-Infrared Model# 463251713. Char-Broil LLC.

The Bottom Line

This model has been discontinued. It is replaced by the Char-Broil Gourmet 3-Burner TRU-Infrared Gas Grill Model# 463251714.

In 2012, Char-Broil brought all its various infrared products under the TRU-Infrared brand name. This grill uses the same technology as previous years RED products with a little more power in the burners to reduce the preheat time. The temperature range of this grill and preheat time is typical of most gas grills.

The advantage of this technology is that it seldom flare-ups and is more efficient than standard grills. The shortcoming is the infrared emitter. The gas burners focus their heat at a porcelain coated metal plate. Since metal expands and porcelain doesn't, the emitter is typically the first part to fail.

Manufacturer's Site


  • High, efficient heating
  • Low price all infrared design


  • Low quality 430 stainless steel construction
  • Cooking chamber trough section prone to rusting and potential failure
  • Decals on the stainless steel rub off


  • Three 10,000 BTU stainless steel tubular burners
  • 500 square inches primary cooking area with a total grilling area of 680 square inches
  • 30,000 BTU maximum output from the main burners
  • 13,000 BTU standard side burner under a flush mounted cover
  • Unique "infrared" design produces high temperatures from a low BTU output
  • Heavy porcelain coated cast iron cooking grates
  • Push button electric (AA-Battery) igniter
  • Painted steel and stainless steel (400 series) construction
  • Propane tank, rotisserie kit, and cover sold separately
  • Made in China by Char-Broil exclusively for Home Depot

Guide Review - Char-Broil Gourmet 3-Burner TRU-Infrared Gas Grill Model# 463251713

In the past Char-Broil's RED technology (now under the TRU-Infrared brand name) has had a few problems.

The focused heat of the burners on a porcelain painted metal tub caused the protective layer to peel off. This exposed the raw metal to corrosion, greatly limiting the lifespan of these grills. Recently, Char-Broil has done some redesigning of the RED grills to address the problems. The firebox has been changed to a single piece unit and the burners pulled away from the infrared emitter and turned around to heat the space under it. The BTU output from the main burners has been boosted to reduce the long preheat times that the RED technology requires.

To recap (because if you're reading this you probably don't know much about these grills, the Char-Broil TRU-Infrared 3-Burner Gourmet focus the heat of its burners onto a rounded piece of porcelain coated sheet metal called a U-Emitter (or trough on the technical specs). The U-Emitter gets very hot (around 950 degrees F.) and radiates heat at the heavy porcelain coated cooking grates. This gives you 100% infrared cooking power. What that means is high, intense heat for grilling without flare-ups (says the literature).

Two problems with these grills are, first that any drippings into the U-Emitter must be completely vaporized. This produces a lot of smoke (and not the good kind) and sometimes rather intense flare-ups.

The other problem is that the heat focused on the U-emitter causes the porcelain coating to flake off and expose the metal to the elements. This will lead to rusting. Once this rusts through the grill will be unusable. Warranty on this part is two years but doesn't cover rusting.

So the big question is, do the changes Char-Broil has made fix these problems. I would love to be able to tell you that right now, but it is simply going to take time to figure that out. What I see is that the grill can now heat up faster. The 20 to 25 minute preheat times have been reduced by boosting the burner output. Unfortunately, this doesn't solve the problem of the superheated U-emitter losing its protective coating. As for the smoke and the rare but spectacular flare-ups? Those will still happen.

This grill comes equipped with a standard function 13,000 BTU side burner.

Since the burners are isolated there is virtually no chance of flare-ups and so you won't need a rotisserie burner. Basically, this is a full function gas grill (rotisserie kit optional) for around $450USD.

The rest of the grill uses a combination of painted steel and lower grade stainless steel with plastic knobs. The stainless steel body parts are prone to discoloring and rusting over time so this grill needs to be kept clean and protected from the elements. If you buy this grill make sure you get a good cover for it.

Manufacturer's Site