Curing live rock in a separate curing setup is the best way to handle it before placing it into a new saltwater system you are just starting. Unfortunately, this is not always practical for everyone, as you may not have the extra room or equipment to do so. If the only container you have to work with to cure live rock in is the tank you are setting up as your main aquarium, here is a simple way to cure it inside the aquarium, preferably before you add substrate and start aqua scaping the rocks.
Time Required: Varies
- If the aquarium already has saltwater in it, and/or the system is set up and running, first turn off all the equipment, remove any devices that may get in the way, and take out and save about 1/2 of the saltwater in the tank. (The reason for this is that the water level will rise when the rocks are put into the tank.)
- If the aquarium is empty, you can either fill it about 1/2 full with prepared saltwater or mix the saltwater solution in the tank if you need to, then remove about 1/2 of the saltwater when it is ready for use.
- Preclean the rocks, place them into the aquarium, and top-off the water level if needed.
- Only turn on the heater(s), and water/powerhead pump for oxygenation and circulation.
- Let the rocks cure! This means you DO NOT add live sand or another substrate, livestock, or anything else until the curing process is complete. So how do you know when it is "cured"? You can test for ammonia and nitrite, and when you get zero readings, the process has reached completion. Often you can also tell by smelling the water. If there is no odor to the water, it usually means the process is done.
- While the rocks are curing, periodically siphon out any accumulated organic matter off the bottom of the tank, top-off the water level when needed, and keep an eye out and remove any unwanted animals or organisms that may have been missed when the rocks where precleaned.
- Once the curing process is complete, siphon out any debris off the bottom of the tank, and do a substantial water change.
- This procedure is best done using a bare tank. Why? Because when die-off occurs, the dead or dying organic matter that creates ammonia can more easily be removed as it accumulates, which in turn helps to shorten the rock curing or cycling time. This also prevents excess organic matter from building up in the substrate, which can lead to high nitrate and problems with brown diatom and other type algae blooms during and after the aquarium cycling process.
- Of course, you can opt to bypass curing the live rock altogether, but it is suggested to consider allowing the rocks to cure for at least a few days in this way, before adding the substrate and aquascaping the rocks.
- If you decide not to first cure the rocks, but intend to add the substrate and live rock to cycle the aquarium with, it is recommended to at least take the time to preclean the rocks before using them. This will help to eliminate some of the build-up of organic matter that will result from die-off, and you can inspect the rocks for any undesirable critters that may be present and remove them.
- You should consider raising the rocks up off the bottom of the tank for this procedure. It will provide more water circulation underneath and around the rocks and makes it much easier to siphon out the dead or dying organic matter that can build-up during the curing process.
What You Need:
- A Set-Up Saltwater Aquarium
- Live Rocks
- Ammonia Test Kit
- Nitrite Test Kit