Free Pattern and Directions to Sew a Men's Bi-Fold Wallet

  • 01 of 05

    Sew a Men's Bi-fold Wallet - Materials and Cutting Directions

    Finished Men's Billfold
    Finished Men's Billfold. Debbie Colgrove

    Materials Needed

    • Fabric
    • Double fold bias tape
    • Print out of pattern
    • Fusible Craft weight interfacing such as Pellon Craft Fuse

    Cutting

    • Cut each piece, folding back the pattern for each line, on a fold to obtain four cut pieces.
    • Interface each piece and repress the fold.
    Continue to 2 of 5 below.
  • 02 of 05

    Sew Credit Card Sections

    Sewing the Credit Card Sections
    Sewing the Credit Card Sections. Debbie Colgrove
    • Un-fold piece B.
    • Starting at the bottom, stack C pieces, separating them by approximatly 3/4 inch, keeping them even and aligned with the ends.
    • Pin the top of the C sections.
    • Baste the bottom of each C section, folding the first one back to expose and baste the second C section.
    Continue to 3 of 5 below.
  • 03 of 05

    Center Stitching

    Center Stitching
    Center Stitching. Debbie Colgrove
    • Fold to find the lengthwise center.
    • Stitch 1/4 inch on each side of the center through the ​C sections and one layer of the B section.
    Continue to 4 of 5 below.
  • 04 of 05

    Align Edges and Round Corners

    Edges & Rounding
    Edges & Rounding. Debbie Colgrove
    • Refold section B.
    • Stack all of the pieces, aligning the bottoms and ends.
    • Trim all edges if necessary to have an even edge of all the joined pieces.
    • Using a round template, such as a quarter, small plate or drinking glass, round off all four corners of the joined pieces.
    • Baste and zigzag the edges to condense the edges.
    • Press well.
    Continue to 5 of 5 below.
  • 05 of 05

    Edge With Bias Tape

    Edge with Bias Tape
    Edge with Bias Tape. Debbie Colgrove
    • Starting at the bottom of the wallet, sew bias tape to the entire edge of the wallet, folding over the end of the bias tape to enclose the raw end of the bias tape.

      Problems catching all of the bias tape with the bulk involved can be over come by condensing the edges with pressing and a zigzag stitch. You can also use a decorative stitch on the bias tape.