01 of 04
How to Make a Comfy Puff Quilt
Learn how to make puff quilts with this easy puff quilt pattern. These super comfy quilts look and feel a bit like comforters. They are assembled by sewing squares of fabric together to form pockets and then stuffing the pockets with fiberfill.
Puff quilts are often called 'biscuit' quilts. This technique differs from the traditional method used to make the quilts so before you begin, read the pattern to get a feel for the entire assembly process.
Unless you're planning on a totally random... layout, it's a good idea to design a puff quilt before choosing fabrics. First, use graph paper or another method to create a grid that's 9 squares across and 11 squares tall. Fill in the blanks with colors or with shades-of-gray color values to design the layout.
Fabric and Supplies for a Baby Puff Quilt
- 3 yards of fabric for top squares (can be orderly or scrappy)
- 2 yards of muslin or another fabric for back squares (will not be visible in the finished quilt)
- 1 yard of fabric for (final) backing
- 1-1/2 packages double fold bias tape (or make your own binding)
- Embroidery floss & needlepoint needle
- Polyester fiberfill (1 bag or a little more)
- The finished quilt will measure about 32" x 38"
- Cut (99) 6" x 6" top squares
- Cut (99) 5" x 5" squares of muslin (or other fabric used for back squares)
Assuming the fabric has a usable width of at least 40":
- You can cut (6) 6" squares from a 6" wide strip of fabric cut from selvage to selvage (possibly 7 if the usable width is 42").
- You can cut (8) 5" squares from a 5" wide strip of fabric cut from selvage to selvage.
More About Quilting FabricContinue to 2 of 4 below.
02 of 04
How to Pin Puff Quilt Squares Together
Continue to 3 of 4 below.
- Pin a top fabric square to a smaller muslin square (the wrong side of the top square should be against the muslin). Match all corners and center the top square's resulting pleats as shown. Leave one side of each pocket unpinned for stuffing later.
- Repeat, pinning all top squares to a muslin square.
- Arrange pinned squares into rows, orienting all pleats in the same direction.
- Use a 1/2" seam allowance to sew square pockets in each row together. Do not remove pins from unsewn edges. (Photo)
- Sew... a 1/2" seam along the sides of outermost pockets.
- Place each row back into its place within the layout.
- Sew a 1/2" seam along the bottom edge of each row (Photo), orienting short seam allowances to flow in opposite directions from row to row so that they will nest together nicely when rows are joined. Remove pins from row bottoms after sewing.
- Use the openings along the tops of rows to stuff each square with fiberfill. Fill squares nicely, but avoid over-packing -- too much stuffing will make it difficult to pin and sew rows together.
- Sew a 1/2" seam allowance along the open edge of the top row.
- Pin and sew rows together, nesting seam allowances.
Photo: front and back of puff quilt
03 of 04
How to Make Backing for a Puff Quilt
- Place the puff quilt's backing fabric right side down on a table. Place the quilt on top, right side up (the longest edge of a quilt this size will usually fit across the width of the fabric).
- Use safety pins or tacks to hold the layers together.
- Thread embroidery floss through a needlepoint needle and tie each corner of a pocket with a square knot. Move from the upper right to the lower left. (Photo)
- Remove tacks or pins and trim backing even with sides of the puff quilt. Baste or zigzag... stitch around the edges of the quilt.
Check out this tutorial on how to tie a quilt.Continue to 4 of 4 below.
04 of 04
Sew Binding to the Puff Quilt
- Pin bias tape around the quilt.
- Sew binding to the quilt with matching thread, using a wide zigzag setting and short stitch length. You could also bind the quilt with double fold mitered binding.
- Launder the puff quilt. You're finished!
Change the Quilt's Dimensions
- To make puff quilts with squares of a different size, cut the back squares 1" smaller than the top squares.
- When making miniature puff quilts, try cutting the back squares 1/2" smaller than the front squares, and use a 1/4"... seam allowance for all seams.
- Experiment with sizes to see what works best.