Make a Hot Pot Handle Cover

  • 01 of 03

    Materials and Cutting Directions

    Padded Pan Handle Pot Holder
    Debbie Colgrove

    The following directions are for a pan handle that is 6" by 1" wide. If your pan handle is different, adjust the measurements to suit your need.


    • Fabric - Preferably cotton - not a synthetic fiber that will melt easily from heat—2 pieces cut to 6" by 4 1/2"
    • One low loft batting such as warm and Natural—cut 6" by 4 1/2"
    • One Insul-Bright (TM) (or a second layer of low-loft batting)—cut 6" by 4 1/2"
    • Sewing machine
    • Hand sewing needle and thread
    • Optional but...MORE recommended—Rotary Cutting Tools to assure accurate cutting—more information about rotary cutting tools
    Continue to 2 of 3 below.
  • 02 of 03

    Machine Sewing

    Machine Sewing Details
    Debbie Colgrove
    • Layer all of the pieces in the following order.
      • Low loft batting
      • Fabric (right side up)
      • Fabric (right side down)
      • Insul-Bright
    • Align all of the edges and pin the layers together.
    • Leaving a 2-3" inch opening on one 6" side, sew around the edges using a 1/4" seam allowance.
    • Trim away the corners to remove bulk.
    • Trim away batting seam allowances if possible to remove bulk.
    Continue to 3 of 3 below.
  • 03 of 03

    Hand Sewing

    Hand Sewing Details
    Debbie Colgrove
    • Turn right sides out and press well.
    • Slip stitch the opening closed (How to sew a slip stitch)
    • Gently fold the tub in half to butt the 6" edges.
    • Slip stitch the edges together to form a tube.
    • Place the slip stitched seam as shown in the photo and slip stitch the end closed.
    • Place on pan handle when you need it but never leave it on the pan and unattended while you are cooking.