Make Your Own Saltwater Aquarium Wavemaker

Saltwater Aquarium
  • 01 of 03

    Simple Saltwater Aquarium Do-It-Yourself DIY Wavemaker

    Saltwater Aquarium
    Wikimedia Commons
    • Project: A simple, inexpensive, effective wavemaker.
    • Purpose: To create wave motion in the tank and aid with water circulation.
    • Degree of Difficulty: Moderately easy.

    Using wavemakers, oscillators or surge devices to create good water current movement in your aquarium is important. You can always purchase these devices, but for the do-it-yourselfer, what's the fun in that? This DIY project is a very simplistic method for creating a "back-and-forth" wave motion using only two...MORE powerheads, and no outside electronic devices. Originally I used three powerheads, but since found that only two are necessary to give a nice alternating current. The patterns will vary at first, but eventually the currents will settle down into a "normal" cycle.

    DIY Wavemaker - Parts List

    • 2 matching Powerheads, i.e. Hagen 402's, Rio 1700's, etc. (Read reviews & compare prices)
    • 1 - 1/2" PVC 90 degree elbow.
    • 1 - 1/2" PVC 45 degree elbow.
    • 1 piece of 1/2" PVC pipe, approximately 2", cut in
    • to two pieces 1" each in size.
    • Small tube of all-purpose PVC cement.
    Continue to 2 of 3 below.
  • 02 of 03

    DIY Wavemaker - Assembly

    DIY Wavemaker. Graphics by Don Carner
    • Glue the first 1" length PVC pipe into one end of the 90 degree elbow.
    • Glue the 45 degree elbow to the other end of the first 1" PVC pipe.
    • Glue the second 1" piece of PVC pipe into the other end of the 45 degree elbow. The length of the second piece of PVC pipe can be shorter, if you prefer.
    • The PVC 90 degree elbow will slip-fit over the Hagen output nozzle without modification. Allow the assembly to completely dry before placing on one of the powerhead output nozzles.
    The completed...MORE assembly should resemble the diagram above:

    Note: The 1/2" PVC pipe and fittings are normally tight enough that they can be assembled and used without gluing. Doing so will allow you to adjust the water flow to suit your needs before permanently gluing the parts.

    Continue to 3 of 3 below.
  • 03 of 03

    DIY Wavemaker - Powerhead Tank Positioning

    DIY Wavemaker Location. Graphics by Don Carner
    The powerhead that is mounted in the rear corner of the tank does not require a PVC assembly attachment. Simply direct it's output nozzle so as to point 45 degrees to the front of the tank, or to an "imaginary point" in the middle of the aquarium.

    The center powerhead has the PVC assembly attached and directed straight ahead pointing down 45 degrees. The PVC elbow assembly makes this possible. Remember that the 90 degree elbow will "slip-fit" onto the output nozzle of the...MORE Hagen 402 powerhead without modification.

    Both pumps are mounted on the rear glass/acrylic side, at the water's surface, and the output nozzle adjustment is crucial.

    It may sound complicated, but once you actually get the PVC attachment onto the center powerhead, and place the powerheads into the tank, it will all make sense.

    Plug both pumps in and stand back!! The wave motion will become apparent when feeding, as the foods gets swirled back and forth in the created wave motion current.