01 of 05
Setting up the Turkish Cast On
Just as with any other kind of knitting, there are numerous ways to cast on stitches for toe-up sock knitting. The best method for you is going to be found after trying a variety of options, but I like one that's known as the Turkish cast on, mostly because it is relatively easy and doesn't require the use of waste yarn as some provisional methods of casting on for toe-up socks do.
You'll probably want to practice a couple of times before you use it on a real sock, because you're... working into loops so the tension can come out pretty uneven. But it's quick and easy to cast on this way, so you won't mind too much if you have to rip it out and try again.
This method can be done with two circular needles as shown, or start with two double-pointed needles and distribute the stitches onto one or two more as you go, depending on your preference for how many needles to work with.
To begin, align your needles with the points facing to the right and put a slip knot on the lower needle.Continue to 2 of 5 below.
02 of 05
Casting on Stitches
"Cast on" feels like the wrong term for what's happening with the Turkish cast on because you're really just wrapping the yarn around the needle. Even as I say this it will feel like you're doing something wrong because you're doing so little, but that's really all you do.
Take the yarn from under the needles around the back and over top of the needles and back to the front of the needles and so on, looping around both needles as you go each time.
Repeat until... you've made enough loops to account for half your needed stitches, minus one. In this example we were going for 20 stitches, which means I needed nine loops.
Wrap the yarn around the top needle one more time and bring the yarn between the needles. Now there are 10 "loops" on each needle (counting the slip knot on the bottom needle).Continue to 3 of 5 below.
03 of 05
Starting to Knit
Pull gently on the bottom needle so the loops (or stitches) that were on that needle hang on the cable. Using the point of the other end of the top needle, knit the "stitches" on the top needle.
Yes, this will be awkward. As I mentioned, keeping an even tension will be difficult. It will get easier with practice.Continue to 4 of 5 below.
04 of 05
Completing the First Round of Knitting
Once you've worked the first needle's worth of stitches, slide them onto the cable needle and move the bottom stitches onto the end of the needle closest to where the working yarn now is so that you can knit those stitches using the other end of the same needle.
The first stitch you will work on this side, then, is the slip knot. Be extra careful to knit with the working yarn rather than the tail end. I can't tell you how many times I picked up the tail to knit with just when working... on this tutorial. (Yes I can. It was four.)Continue to 5 of 5 below.
05 of 05
Continuing the Sock
For the purposes of practicing this cast on method, work a few more rounds of straight knitting just to see what it looks like. In this picture I've worked three rounds, and you can already start to see the toe shape happening.
Most toe-up sock knitting patterns have you start increasing for the foot right away, so if you're following a pattern you'll want to pay attention and start your shaping when the pattern tells you to.