Why and How Leather Corals Shed

Leather coral
Jeffrey Richards / Getty Images
  • 01 of 05

    Why and How Leather Corals Shed

    Leather Coral Before Shedding. Photo © Debbie and Stan Hauter

    Some Leather or Family Alcyoniidae corals periodically slough-off a thin top layer of tissue. This shedding process is apparently not a regenerative action, but one that serves to rid the coral's surface of accumulated waste, debris, and algae. Once a coral has shed what could be described as a layer of "old skin", it's not unusual for it to appear larger and more magnificent than before.

    Sarcophyton, Lobophytum and Sinularia species leather corals are those that regularly go...MORE through this shedding process, as shown in this sequence of Toadstool Mushroom Leather Coral pictures.

    By using the Clam in this first picture as a gauge, you can get a general idea of the width and height of the coral before it shed.

    Continue to 2 of 5 below.
  • 02 of 05

    The First Phase of Shedding

    Leather Coral Shedding - First Phase. Photo © Debbie and Stan Hauter

    This photo shows how the Toadstool Mushroom Leather Coral looks several days after performing a simple cleaning procedure of the substrate in our 92-gallon reef tank. It was determined that due to the amount of fine sediment that was suspended in the water from stirring up the sand, and periodically blowing water over the coral with a turkey baster to remove any debris that settled on top of it, this caused the coral to respond and go into the shedding mode. It should be noted that we had a...MORE Diamond Watchman Goby (Valencienna puellaris) in the tank which constantly sucked up and sifted the sand in the tank, spreading it all over everything, including the corals.

    In the first phase of shedding, the coral closed up and shrank, and the surface took on a waxy appearance. The coral remained in this stage for several days before it actually started to shed, as seen in the next picture.

    Continue to 3 of 5 below.
  • 03 of 05

    The Second Phase of Shedding

    Leather Coral Shedding - Second Phase. Photo © Debbie and Stan Hauter

    In the second phase of shedding, here you can clearly see a thin, slimy-like membrane peeling away from the surface of the Toadstool Mushroom Leather Coral. In the area where sloughing already occurred, the coral's polyps started to come out again.

    This and the next picture were taken about an hour apart.

    Continue to 4 of 5 below.
  • 04 of 05

    The Second Phase of Shedding Continues

    Leather Coral Shedding - Second Phase Continues. Photo © Debbie and Stan Hauter

    The Toadstool Mushroom Leather Coral continued to shed its outer layer, and in this second phase picture compared to the previous one taken, you can see how the area of shedding widened by looking at where more polyps had emerged.

    This transition progressed until the coral had completely rid its top surface of "old skin", and as the last photo shows, the coral was fully rejuvenated.

    Continue to 5 of 5 below.
  • 05 of 05

    The Shedding Process Completed

    Leather Coral Shedding Process Completed. Photo © Debbie and Stan Hauter

    From start to finish, the complete process of the Toadstool Mushroom Leather Coral shedding its "old skin" transpired over about a seven day period.

    This picture shows the coral in its full splendor after shedding. Once again using the Tridacna crocea Clam in the photo as a size gauge, and comparing it with the first photo shown, you can see the end result. The coral is larger and even more magnificent than before.